Add files via upload

README.txt

@@ -0,0 +1,47 @@
+Welcome to the LC-3 in Logism!
+
+This processing unit can perform basic arithmetic, logic, and memory operations. 
+The following instructions are supported: ADD, AND, NOT, LD, LDR, ST, and STR. Here is an example list
+of some pre-tested instructions that you can perform (in no particular order):
+
+1401 = ADD R2, R0, R1
+1883 = ADD R4, R2, R3
+
+c000 = JMP R0
+
+260a = LD R3 #10
+6649 = LDR R3 R1 #9
+
+3403 = ST R2 #3
+778a = STR R3 R6 #10
+
+To run any of these instructions: enter the 4-digit hex-code(s) into the RAM unit found in the
+'main' circuit, enter values into the appropriate registers found within the 'Registers' circuit 
+to be operated on, and begin ticking the clock. To restart the system, use the hand that allows 
+you to change values (ctrl+1) and double click on the magnifying glass to enter the controlUnit. 
+Within the controlUnit, reset the 'phaseCounter' and the register labeled 'PC' to 0 and then
+you're good to go.
+
+To note when using this processor: any ST instruction (not STR) should use an offset value of one-
+less than the offset that would get to the address you want to store at. The order in which the phases
+change data causes the 'pcSelector' to receive an already-incremented PC value, so when the offset is
+added during phase 3, the destination value is written one spot above the originally intended address.
+Also, if the Logisim gives a 'label collision' error when loading the circuit, just rename any of the
+tunnels that output blue wires in the 'main' circuit to 'clock'. Otherwise, everything should work as
+intended.
+
+All of the tests listed above were previously tested with various register values and proved to work
+as intended. The AND and NOT operations were also tested early in the building process and once the
+ALU was completed it has not been modified so there was no reason to retest. The LD and LDR operations 
+properly read from the address instructed and store to the correct register, ST stores the value found
+within the source register but the offset needs to be subtracted by one to store to the proper address,
+and STR stores the value found within the source register to the intended address without any 
+accommodations to the offset or base register. Since all of these worked as intended, I came to the 
+conclusion that they were good tests. I also ran a string of instructions in a row that read a value,
+added two values together, jumped ahead 30 addresses, and then stored a value 3 addresses ahead of the
+PC, and after several full phase cycles the PC incremented properly up to the stored value from the 
+store address. Everything worked as far as I could tell and I think that these are good tests for the
+instructions.
+
+All circuits were designed to be easy to follow and feature documentation describing some of the specific
+aspects of the system.