osheas1atwit
29 lines
1.3 KiB
Plaintext
29 lines
1.3 KiB
Plaintext
tips i have picked up online:
|
|
- dont use too much glue, just enough to spread everywhere
|
|
- use an extra piece of veneer wrapped in packaging tape as a squeegee to apply glue evenly
|
|
- use a very light coat of gorilla glue on only the top side of the first 4 pieces of veneer
|
|
- leave the deck in the mold for 24 hours
|
|
- leave it in the sun or a lamp after you take it out to make it stronger
|
|
- when drawing the shape make sure to put it right in where the mold was.
|
|
- when sanding use some sort of electric sander or a dremel. makes it easier and better.
|
|
- if hand sanding dont press the board to hard it might mess it up
|
|
- drill the holes after you sand
|
|
- when drilling try drilling really slow for nice holes that are not torn up.
|
|
- take care when doing king pin holes, try make them as neat as posible
|
|
- when doing a graphic, if its a sticker,put it on after its shaped, its ifs a burn/engrave/print etc... do it before you mold it.
|
|
- laquer at least 4 times and let it dry to the fullest each time also sand a little bit every time until your final coat.
|
|
|
|
|
|
|
|
|
|
!!!!!! print your mold top and bottom on their sides at .2mm layer height to lose those really rough layer lines that will get clamped into the deck
|
|
|
|
|
|
hardware info:
|
|
|
|
Single Bearing: 1.5 x 4 x 2mm
|
|
Dual Bearing: 1.5 x 4 x 1.2mm
|
|
Lock Nut / Machine Screws: 0-80
|
|
|
|
wheel info:
|
|
~7.7mm diameter, ~4.9mm wide |