adding site files

site/logs/fb.txt

@@ -0,0 +1,29 @@
+tips i have picked up online:
+- dont use too much glue, just enough to spread everywhere
+- use an extra piece of veneer wrapped in packaging tape as a squeegee to apply glue evenly
+- use a very light coat of gorilla glue on only the top side of the first 4 pieces of veneer
+- leave the deck in the mold for 24 hours
+- leave it in the sun or a lamp after you take it out to make it stronger
+- when drawing the shape make sure to put it right in where the mold was.
+- when sanding use some sort of electric sander or a dremel. makes it easier and better.
+- if hand sanding dont press the board to hard it might mess it up
+- drill the holes after you sand
+- when drilling try drilling really slow for nice holes that are not torn up.
+- take care when doing king pin holes, try make them as neat as posible
+- when doing a graphic, if its a sticker,put it on after its shaped, its ifs a burn/engrave/print etc... do it before you mold it.
+- laquer at least 4 times and let it dry to the fullest each time also sand a little bit every time until your final coat.
+
+
+
+
+!!!!!! print your mold top and bottom on their sides at .2mm layer height to lose those really rough layer lines that will get clamped into the deck
+
+
+hardware info:
+
+Single Bearing: 1.5 x 4 x 2mm
+Dual Bearing: 1.5 x 4 x 1.2mm
+Lock Nut / Machine Screws: 0-80
+
+wheel info: 
+~7.7mm diameter, ~4.9mm wide